Crown IQ3USP3CN

Crown IQ3USP3CN

The PIP-USP3CN module includes all of the features of the PIP-USP3 as well as integrating CobraNet transport in the same single 100-MB Ethernet connection. Signal routing is easily controlled via FREE IQWic software. The PIP-USP3CN also provides two analog audio inputs that can be configured as a redundant signal or for page-over applications. Saves audio bandwidth within the CobraNet network by providing local signal processing of the signal at the amplifier. Also features amplifier output listen bus that allows you to route the amplifier output signal back through Ethernet to a central listening position.

Crown IQ3USP3CN Features:

• 100Mb Ethernet single-plug solution for both CobraNet audio and TCP/IQ control and monitoring
• Analog audio inputs allow CobraNet network audio input, CobraNet audio backup, or a hardwire emergency override of CobraNet audio
• "Listen Bus" amplifier output monitor via CobraNet
• 24 bit digital to analog conversion with 32 bit, floating point DSP processing
• 64 assignable filters with 9 different filter types including all-pass filters
• Over 2 seconds of delay available per" channel
• Input compressors and output limiters for each channel
• Dual, uncorrelated noise generators for noise masking
• Sine generator
• Load supervision
• Full error reporting
• Firmware upgrades via the network
• 10 user selectable presets
• Reliable FLASH memory backup of all parameters
• Three Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications

Crown IQ3USP3CN Specifications:

• Balanced Audio Input Connector : Single 5-pin removable barrier-strip connector for both channels
• AUX Connector : Configurable for AUX input or AUX output. Listen Bus is available through CobraNet
• Communications : 100Mb Fast Ethernet conforming to IEEE 802.3
• Power Requirements : (provided by the amplifier): +24VDC @ 350mA, 24VDC @ 30mA. < 8.7 Watts
• DSP Processing : 32 bit, Floating Point, 665 s latency
• DAC Conversion : 24 bit, 135 s latency
• Dynamic Range : 103 dB typical (A-weighted, 20Hz 20kHz, audio sourced from muted CobraNet channel)
• Distortion : < 0.05 % THD+N, 20Hz 20kHz
• Frequency Response : 0.5 dB, 20Hz 20kHz
• Input/Output Monitor Accuracy : Typically 1dB
• Input Impedance : Nominally 20 k ohms balanced, 10 k ohms unbalanced
• Maximum Input Level : + 20 dBu
• ADC Conversion : 18 bit, 312 s latency
• Signal to noise ratio : 70 dB typical (Aweighted, 20Hz-20kHz)
• Crosstalk : > 60 dB
• Common Mode Rejection (CMR) : 50 dB typical
• Distortion : > 0.05% THD+N, 20Hz 20kHz
• Frequency Response : 0.5 dB, 20Hz 20kHz

Get your Crown IQ3USP3CN today!